Snowboarding is a sport of gliding on snow. The equipment consists of a snowboard where the “board” is referred as a “plate”, a pair of brackets that may be of different types, and a pair of proper shoes or boots. The position on the board is modeled on that of surfer profiles, feet through one after another.
Snowboarding is inherently asymmetrical. There are two possible positions; that are “Regular” and “Goofy”. A regular position holds the right foot at the rear; while the goofy position holds the left foot back.
There are several types of techniques and vocabulary slips. These are illustrated as following:
Frontside position: The rider is resting on the toes. The position resting on the toes can be called toeside (from toe: toe and side: side).
Backside position: The rider is resting on your heels. We can make the same remarks on the etymology of frontside. This position is also known as the heel side.
Carre frontside: This position holds square as the side which lays toenails.
Backside edge: The edge that lies on the side of heel.
Dead leaf: The technique of dead leaf is an alternative to turning over safe for beginners, or on the tracks really difficult. It is to remain supported on one side of the board, and his weight alternately on one foot then the other. This helps track down gently slip to the left, then right, and so on. The trajectory thus resembles that of a dead leaf.
Crossing: snowboarding is a movement of the surfer and his board in a direction transverse to the slope of the hill. Unlike skiing there are two types of crossings according to whether one is resting frontside or backside.
Base turn: It is simply a rotation of the plate while sliding on snow in a position supported on one side of the plate to another. In short of the support will turn on the interior side of the board to turn so it is necessarily accompanied by a strong inclination more or less the surfer toward that side. The position of the rider is not on the front board, corners are asymmetric simple. We can not do directly with the left and right because it changes depending on the position that one has to do. It is common to find among snowboarders a big gap between the technical mastery of the curves. Against the skills mentioned above, the techniques snowboarders can master are counter rotation, pre-rotation and co-rotating.
Counter rotation: This technique is more or less end of the ski. The shoulders of the rider must remain facing downhill whenever possible. In both curves, snowboarders bear his weight on his front foot, which gives the direction of travel. This technique is most commonly used by racers in slalom, especially because it allows for faster turn initiation.
Pre–rotation: This technique is visually more than surfing, although bio-mechanically the two are quite different. The shoulders rotate the initiation of the turn to indicate the desired direction with the shoulder forward (downstream). The rotation is most often accompanied by a shift of body weight on the leg before to support with the toe or heel, depending on the desired direction. This technique is most commonly used by competitors in freestyle.
Co-rotating: This technique is specific to the modern snowboard. The shoulders should remain permanently in the alignment of the board. To this end, we often use symmetrical angles fixing “a duck”.
Snowboarding discipline is relatively young. It is enriched and modified regularly. Today the technique taught depends more on the past and the preferences of the instructor or monitor. Each person can choose according to their preferences, in addition, control of different techniques improves the versatility of snowboarders.
Users reading this article about snowboarding techniques may also be interested in:
Incoming search terms:
- backside edge
- backside edge snowboard
- snowboard co-rotation